2 0 0 6
VOLVO
S60
| Interior |
| Front seats | 58 |
| Interior lighting | 62 |
| Floor mats | 63 |
| Storage compartments | 64 |
| Rear seat and trunk | 68 |
| Spare wheel, tools and jack | 70 |
Manually adjusted front seats
1. Front-rear adjustment: lift the bar and
move the seat to the position of your
choice.
2. Raise/lower the front edge of the seat
cushion (option): use the control to pump
the front edge of the cushion up or down.
3. Raise/lower seat height: pump the seat up
or down
4. Lumbar support: turn the control for firmer
or softer lumbar support.
5. Backrest tilt: turn the control to adjust the
angle of the backrest.
6. Control panel for optional power seat (see
page 60 for more information).
- Do not adjust the seat while driving. The
seat should be adjusted so that the brake
pedal can be depressed fully. In addition,
position the seat as far rearward as comfort
and control allow. |


Folding the backrests in the front
seat
The front passenger seat backrest can be folded
to a horizontal position to make room for a long
load. Fold the backrest as follows:
Cover sharp edges on the load to help prevent injury to occupants. Secure the load to help prevent shifting during sudden stops. |
Power seat - (option on certain models)
Operation
Driver's seat: The seat can be adjusted if the
ignition key is in position I, II or if the engine is
running.
It can also be adjusted as follows with the
ignition off:
Passenger seat: The seat can only be adjusted if the ignition key is in position I, II or if the engine is running.

Seat adjustment
If your Volvo is equipped with power seats, the
following may be adjusted with the two
switches at the side of the seat:
A - Front edge of seat (raise/lower)
B - Front-rear
C - Rear edge of seat (raise/lower)
D - Backrest tilt
NOTE! The power seats have an overload protector that activates if a seat is blocked by any object. If this occurs, switch off the ignition (key in position 0) and wait about 20 seconds before operating the seat again.
Please refer to the following page for information on programming the memory function in the driver's seat.
Remote keyless entry system and
the driver's seat
The remote control transmitter also controls the
position of the electrically operated driver's
seat in the following way:
1. Adjust the seat to your preferences.
2. When you leave your vehicle, lock it using
the remote control.
The position of the seat is now stored in the
remote control.
Automatic seat adjustment
To move the seat to the position in which you
left it:
1. Unlock the driver's door with the same
remote control (the one used to lock the
doors)
2. Open the driver's door within 2 minutes.
The driver's seat will automatically move to the
position in which you left it.
NOTE:
NOTE: This feature will not function if your lock your vehicle with the key.
Because the driver's seat can be adjusted with the ignition off, children should never be left unattended in the car. Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel. Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be depressed fully. In addition, position the seat as far rearward as comfort and control allow. The seat rails on the floor must not be obstructed in any way when the seat is in motion. |

Programming the memory (option)
Three different seating and door mirror
positions can be stored in the driver seat's
memory.
The following example explains how button 1
can be programmed.
Buttons 2 and 3 can be programmed in the same
way.
To program (store) a seat position in button 1:
1. Move the seat to the desired position using
the seat adjustment controls (see the
previous page).
2. Press and hold down the MEM (memory)
button.
3. With the MEM button depressed, press
button 1 briefly to store the seat's current
position.
To move the seat to the position that it was in
when button 1 was programmed:
Press and hold down button 1 until the seat
stops moving.
As a safety precaution, the seat will stop
automatically if the button is released before the
seat has reached the preset position.

Courtesy light
The courtesy light can be turned on or off by
pressing the center button. The light also has a timer
function which turns the light on for 30 seconds
if:
The courtesy light stays on for 10 minutes if one of the doors is left open after the car is unlocked.
The courtesy light switches off if:
The courtesy light can be switched off or on in all situations by briefly pressing the button.
When you switch the light on, it remains lit for 10 minutes.
You can disconnect the automatic function by pressing the courtesy light button for more than 3 seconds. Briefly pressing the courtesy light button again automatically reconnects the function.
The courtesy light timer periods can be changed. Contact your Volvo retailer.

Reading lights - front/rear
The reading lights can be switched on or off by
pressing the respective buttons. These lights
switch off automatically after 10 minutes if the
engine is not running. If the engine is running,
the lights stay on indefinitely. The lights can be
switched off at any time by pressing the button.

Vanity mirror
The light comes on when you open the cover.
Floor mats
Volvo offers floor mats specially manufactured
for your car. They must be properly placed and
secured in the mat clips.
An extra mat on the driver's floor can cause the accelerator pedal to catch. Check that the movement of the accelerator pedal is not impeded. No more than one protective floor covering may be used at one time. |