2 0 0 1
VOLVO
S80

AUM ( Asvanced User Mode)

· With the radio switched off, press and hold the volume wheel down for at least 5 seconds to start the AUM function.

· Turn the 1-20/DISC knob to choose an AUM function (see function list on the right).

· When the function has been chosen, the function's current setting flashes. Press the 1-20/DISC knob to choose an alternative (e.g. ON/OFF, LOW/MID/HIGH, etc., depending on the function).

· Continue to choose function/alternative.

To reset all AUM functions to factory settings, turn the 1-20/ knob until "SET TO DEFAULT" is shown in the display, and then press the same knob. All AUM settings are reset to default position and the radio reverts to normal status (music, news, etc.). To save any changes and revert to normal position, turn the 1-20/ knob until "BACK and SAVE" are shown in the display, and press the same knob. To revert to normal position without saving the changes, turn the 1-20/ knob until "BACK without SAVE" is shown in the display, and press the same knob.

AUM functions (starting position "default" is underscored)

The following functions are available on all audio systems:

· SET TO DEFAULT (See left-hand column).

· ASC (Active Sound Control) ON/OFF - The ASC function automatically matches the sound volume to the speed of the car.

· ASC TABLE - Choose level of the ASC function (LOW/MID/HIGH)..

· SRC ON/OFF - Use this function to activate/deactivate the function which reduces the noise in poor reception conditions. The function is normally used when the radio is in AM mode.

· SRC TABLE - Choose level of SRC function (LOW/MID/HIGH).

· TAPE DOLBY ON/OFF - Activates/ deactivates Dolby noise reduction when you listen to a cassette tape (HU 405/605).

· BACK and SAVE (See left-hand column).

· BACK without SAVE (See left-hand column).

The following functions are available on the HU-801 only:

· AF SWITCHING ON/OFF (automatic frequency update) - The AF function ensures that the strongest available transmitter for a program is selected.

· REGIONAL ON/OFF (regional radio program) - This function makes it possible to continue to listen to a regional transmit-ter, even if the signal is weak.

· EON (Enhanced Other Networks) LOCAL/DISTANT - This function determines whether the radio program you are listening to is to be switched off before e.g. a traffic report or news broadcast (if these functions are selected) only if the signal is strong (LOCAL) or whether the radio must also try to capture weaker signals (DISTANT).

· NETWORK ALL/TUNED - With this function you can decide whether the radio program you are listening to is to be switched off before e.g. a traffic report or news broadcast (if these functions are selected) only if the report is on the channel you are listening to (TUNED), or whether the program is to be switched off regardless of which radio channel the report/broadcast is on (ALL).

pg.138 Audio systems HU-801 - radio

Program type - HU-801 only

The PTY function enables you to select specific types of programs.

To search for a particular program type:

1. Press "PTY" button to initiate the function. The currently tuned station's program type is displayed.
2. Scroll through the list of program types by turning the "1-20/DISC" button.
3. When you have reached the program type you require press the
"1-20/DISC" button to begin the search.
4. If the radio finds a station with the selected program type, it sets it. If the radio finds no station with the selected program type, it will return to its previous function. PTY is then in standby mode and remains so until a program of the selected type begins The radio then changes to the station with the selected program type.
5. The PTY symbol is displayed until the radio finds the selected program type and as long as that program is being transmitted.
6. To manually deactivate this function, press the PTY button again. The PTY function is automatically deactivate after it is used once.
certain models
This function can also be used in the CD mode. Steps 1-4 are the same as described to the left. 5. If there is more than one station with the selected program type, you can select using or the scan button. The PTY function is active until the radio finds the selected program type and as long as the selected station transmits that program type. 6. To return to standby mode, press PTY again. The CD will resume playing until the selected program type is sent again. 7. To deactivate PTY standby, press the PTY button again. The PTY symbol will turn off.

Volume of traffic information/news/PTY -

HU-801 only

If you change the volume when the TP, PTY or NEWS function is active, the new volume setting will be stored automatically.

pg.139 Audio system HU-611/HU-801 - CD player

CD player - on

HU-611: Insert a CD.

HU-801: Insert a CD. If you would like to insert another disc (a maximum of 4 CD's can be inserted in the player), turn the
"1-20/DISC" button so that "CD 2 Load Disc" is displayed. Insert the CD. Repeat this procedure for discs 3 and 4.

Once the disc(s) have been inserted, select the CD function by turning the "SOURCE" knob.

Selecting a disc (HU-801 only)

Turn the "1-20/DISC" knob. The number of the disc and track is displayed.

CD eject

HU-611: If you press this button the CD stops playing and the disc is ejected.

HU-801: The CD currently playing will be ejected. If more than one CD has been inserted, turn the "1-20/DISC" to display the number of the CD you would like to eject and press the CD eject button.

NOTE: For traffic safety reasons, the ejected CD must be removed within 12 seconds or it will be automatically reinserted into the CD player.

Fast winding

Press " " or " " to seek within a track.

Next/previous track

Press " " to skip to the next track or " " to skip to the previous track. The track number is shown in the display. If you have the key pad in the steering wheel you can also use these arrows in the same way.

Random

Press "RND" to connect the random function. The unit plays tracks from the disc in random order. "RND" (random) is displayed as long as the function is activated.

pg.140 Audio system HU-611/HU-801 - CD changer (option)

CD changer

The optional CD changer, mounted in the trunk, can accommodate 10 discs. To load the magazine:

· Slide the cover on the CD changer open.

· Press the eject button.

· Pull the magazine out of the changer and insert the discs.

· Press the magazine back into the changer and slide the cover back into place.

Playing a CD

Turn "SOURCE" to activate CD changer mode. The CD changer continues playing the disc and track that was being played most recently. If the CD changer magazine is empty "LOAD MAGAZINE" is displayed.

Selecting a disc

Turn the "1-20/DISC" knob. The number of the disc and track is displayed.

Fast winding

Press " " or " " to seek within a track.

Next/previous track

Press " " to skip to the next track or " " to skip to the previous track. Disc and track number are displayed. If you have the key pad in the steering wheel you can also use these arrows in the same way.

Random

Press "RND" to connect in the random function. A randomly selected track is chosen from a randomly selected disc. Then a new track is selected in the same way. "RND" (random) is displayed as long as the function is activated.

pg.141 Audio system HU-611 - cassette deck

Cassette deck (HU-611 only) - inserting a cassette

Slide a cassette into the slot with the tape to the right (side 1 or A upwards). The ignition key must be in position I or II before a cassette can be inserted. "TAPE A" or "TAPE B" is displayed. When one side has finished playing the unit will automatically begin playing the other side. If a cassette is already inserted in the cassette deck select cassette play by turning the "SOURCE" knob.

Changing tape direction

Press the "REV" button if you wish play the other side of the tape. The side being played is displayed.

Tape eject

If you press this button the tape stops and the cassette is ejected. To select a new mode (radio, CD) turn the "SOURCE" button. A cassette can be ejected even if the ignition is switched off.

Dolby B Noise reduction

The function is preset. To switch the function off, hold down the " " button until the Dolby symbol in the display goes out. Press the same button again to reactivate the function.

Fast winding

The tape can be wound forward with " " and backwards with " ". During fast winding "FF" (forward) respectively "REW" (backward) is displayed. Fast winding is interrupted if you press the button again.

Next/Previous track

If you press " " button the tape automatically winds forward to the next track. If you press " " button the tape automatically rewinds to the previous track. This feature requires at least a 5 second break between tracks. If you have the key pad in the steering wheel you can also use these arrows in the same way.

pg.142 Dolby Surround Pro Logic HU-801 (option)

Dolby Surround Pro Logic (HU-801 only)

During CD playback, Dolby Pro Logic Surround Sound, together with the speaker in the center of the dashboard, offers you very clear and realistic sound.

The Dolby unit divides the normal stereo channels from left - right to left - center - right. In addition, ambient surround sound is produced by the rear speakers. This ambient surround sound mirrors the resonance of a recording studio.

Most recordings today are made so that the vocalist/soloist is heard from the center foreground while the orchestra is heard over the entire left-right panorama as well as from behind. This enables the Dolby Surround Pro Logic system to provide a unique listening experience.

Dolby Surround Pro Logic

To select Dolby Pro Logic during CD playback, press " PL". "Dolby Pro Logic" is displayed. Press "OFF" to return to 2 channel stereo.

pg.143 Dolby Surround Pro Logic HU-801 (option)

3 channel stereo

To select 3 channel stereo press "3-CH". "3 ch" is displayed. Press "OFF" to return to 2 channel stereo.

Center speaker volume

Set the center speaker volume by pressing the button to extend the control and turning it to the left (quieter) or to the right (louder). A "detent" indicates "normal" volume. Press the button back after setting.

Effect channel volume *

Set the power output of the rear channels by pressing the button to extend the control, pulling it out as far as possible and turning it left or right. A "detent" indicates "normal" power output.

Press the button back after setting (Dolby Surround Pro Logic only).

* The "Effect" button will work only during CD playback in Surround Pro Logic mode.

pg.144 Audio systems - specifications

HU-611/HU-801

Output:	4 x 25 W
(HU-801 optional center speaker)	1 x 25 W plus 4 x 50 W through the supplementary amplifier
Impedance:	4 Ohm.
Voltage required:	12 V, negative ground
Radio
Frequency range:
AM	530 - 1710 kHz
FM	87.9 - 107.9 MHz

"Alarm!" is displayed when an alarm message is sent. The function is used to warn the driver of a serious accident or disaster situation.

The optional supplementary amplifier (HU-801) may be mounted under the front passenger's seat. If the floor of the car has become soaked for any reason, do not turn on the radio. This would cause damage to the amplifier. Contact a Volvo retailer.

pg.145 Audio systems - general information

Cassettes

· Store cassettes in their cases.

· Do not touch the tape surface with your fingers.

· Tapes should not be exposed to direct sunlight or extreme temperatures.

· Keep tapes away from oil, grease and other contaminants.

· For optimal tape deck performance Volvo does not recommend the use of C-120 tapes.

· Take up slack using a pen or a pencil before inserting a cassette in the cassette slot.

Cassette cleaning

We recommend the use of the Volvo Cleaning Cassette available as a genuine Volvo accessory. Regular use improves sound quality, cleans vital parts and prevents tape tangle.

Compact disc care

· Before using a new disc for the first time, remove any burrs in the center/outer edge by running the stem of a pen or similar object around the hole/edge of the disc.

· Use high quality discs only.

· Keep the discs clean. Wipe them with a soft, clean, lint-free cloth, working from the center outwards. If necessary, dampen the cloth with a neutral soap solution. Dry thoroughly before using.

· Never use cleaning spray or antistatic liquid. Use only cleaners specifically made for CD's.

· Use discs of the correct size only (3.5" discs should never be used).

· Do not put tape or labels on the disc itself.

· Volvo does not recommend the use of plastic outer rings on the disc.

· Condensation may occur on discs/optical components of the changer in cold winter weather. The disc can be dried with a clean, lint-free cloth. Optical components in the CD changer may, however, take up to one hour to dry off.

· Never attempt to play a disc which is damaged in any way.

· When not in use, the discs should be stored in their covers. Avoid storing discs in excessive heat, direct sunlight or dusty locations.